• So...it works?
• Before you get started
• Using light penis weights
• How and when you should measure your penis
• Other ways of enlarging your penis
• Flex your muscle
• Penile anatomy
• Make it big
• Just pull it
• Just about all there is to know about milking
• Best friends forever
• Enlargement devices

One of the penile enlargement methods that are on the market is the penis weight. This method was used since ancient times and and it is still used by tribe members in Africa .It involves hanging rocks to the penis to get a longer organ.

In civilized countries the method is applied by hanging custom made or home made weights to the penis.

Though I strongly disapprove with the use of this method it is up to you to choose.
I'll first tell you about the risks of using penis weights:

• Scarring of the penis
• Stretch marks
• Sometimes permanent impotence
• Deformation of the penis
• Damage to the nerves
• Poor blood flow to the penis
• Loss of penile sensitivity

Some men who have tried light penis weights claim that they have had length gains. However the method supposedly works if the penis weights are used for a lot of hours per day.

It seems that the use of light penis weights can restore the foreskin .If your goal is not the growth of the foreskin then you should attach the penis weights so that the glans carries the weight. It is not a comfortable method so if you use it we recommend cushioning.

If you want to try penis weights to see if they do the job for you ,you can use flexible weights that you can tie to your penis without feeling uncomfortable. For example you could try golf club swing weights or wrist weights (1 pound/0.453 grams).

Here are two more devices you can make at home:

Circle Device
It is quite a difficult device to make but if you do construct it you'll see that it was worth it because it is also very compact.

To make your own “Circle Device” you will need:

• lead (or lead-free pipe solder)
• a container in which you will put sand or plaster
• a source of heat (you can use a camp stove or a kitchen stove)
• a ladle (you will melt metal in it)
• vice and hammer

Using a sand or plaster mold cast two metal ingots with the following dimensions : 2.36 inches long (6cm), 1.97 inches wide (5cm) and 0.30 inches thick (0.75 cm). When the ingots have cooled use the hammer and vice to curve them.

After the ingots are curved cover them thoroughly in duct tape in order to avoid the lead touching your skin. Then create a hinge by putting tape on both sides .Keep the pieces as close as possible to the way they'll be when you use them. Hold them in place with two rubber bands.

An alternative is to use wax instead of lead. You need two slabs of wax with the following dimensions :2.36 inches long (6cm), 1.97 inches wide (5cm) and 0.30 inches thick (0.75 cm). Curve the wax slabs to a radius about twice that of your flaccid penis.

Use a disposable container to put enough wet plaster to accommodate the both wax slabs. Put the slabs on the end in the plaster then let the plaster set for an hour or overnight (for best results). After the plaster dried use the heat source to heat it until the was melts and runs out. Be careful not to spill molten wax on open flame. . If you use hot watter to melt the wax be sure the mold has dried thoroughly before you pour the molten metal. Then pour molten metal in forms.

Wait a few minutes then put the mold in cold watter. When it has cooled break the plaster and clean the cast ingots. File the ingots to smoothen any sharp edges.

You can make a similar device using (though the results are poorer):

• a piece of cloth
• lead weights
• needle and thread
• rubber bands

James Joubert
The information provided is good. I had never tried weight before. I had only try Kegel exercises which I had found to be very effective.

Add your comment your name: your e-mail: your comments: